Mounting hardware
The back of the print includes a slot for the screw.
Position and mark
• Place the print against the wall.
• Mark the drilling point at the center of the print. Because the slot is not at the very edge, the print will sit slightly higher than your mark.
• Drill the hole and insert the screw.
Hang the print
Slide the print onto the screw through one of the openings in the slot, then move it toward the center.
Mounting hardware
The back of the print includes slots for the screws.
Use size 4 or 5 screws, leaving them protruding about 0.2 in. (5 mm) from the wall.
Position and mark
Hold the print against the wall with the image side facing the wall. Level it and mark the center of each slot. Because the slots are not at the very edge, the print will sit slightly higher than your marks.
Drill two holes and insert the screws supplied with the print.
Hang the print
Slide the print onto the screws through the openings in the slots, then move it into position.
Precision and accurate marking are key.
For your convenience, we prepared a hanging template for the collage. Attach it level to your chosen wall; we recommend checking the position with a level for the best result.
Position and mark
Use the template to mark the drilling point for each print. Make sure every print has its own marked hole.
Insert a size 4 or 5 screw at each mark, leaving it protruding about 0.2 in. (5 mm) from the wall.
Almost done!
Remove the template and hang the prints.
Precision and accurate marking are key.
Choose the position of the center print and mark it using a level.
For small prints, double-sided tape is all you need.
Attach the center print with double-sided tape.
Almost done!
Use the two wooden spacing guides included with your order: use one to maintain equal spacing between the prints and the other to confirm that each print is aligned with the rest.
That’s it—your collage is ready!
